Outlaw Audio 1070 User Manual download pdf (Page 10)

Outlaw Audio

Owner’s Manual

Remote Control

The Model 1070’s hand held remote controller is a pre-programmed universal

unit that contains an extensive library of IR codes and can control up to seven

other system components in addition to duplicating every one of the Model

1070’s front panel functions. All of these choices are shown on the Model 1070’s

front panel and on-screen displays.

Activate the remote’s backlight by simply touching any pushbutton. This lets

you use the remote comfortably even in a dark room. The backlight stays on

for 5 seconds after you’ve touched a pushbutton.

RC1 Setup button (see pages 42-43)

Holding down this button for three seconds causes the remote to enter

setup mode. In this mode, you can enter an entire set of codes for another

device to be controlled.

RC2 Device Control Selector buttons (see pages 26, 37, 42-44)

Selects the component you want to control with the remote.

Push TNR

to control the Model 1070.

RC3 Numeric keypad (see pages 40-44)

Buttons for control functions requiring you to enter numbers, such as

command code selection when programming the remote, using the

tuner, selecting CD and DVD player tracks, etc.

RC4 Mute button (see page 38)

Mutes the Model 1070’s output. Pushing the button again restores the

volume to its previous level. Changing the front panel or remote control

volume setting also releases the mute function. Mute status is shown on

the front panel display.

RC5 Volume Up/Down buttons (see pages 38, 42-44)

These buttons control the Model 1070’s volume.

RC6 Sleep button (see page 39)

Activates the sleep timer, putting the receiver into Standby mode after a

certain period. The ﬁrst push sets the timer at 90 minutes; subsequent

pushes scroll though 75, 60, 45, 30, 20, 10, 5 minutes, and Off. Once the

timer is set, pushing this button again displays the remaining time on

both the front panel and the on-screen display.

RC7 Guide/Test dual function button (see page 39)

Model 1070

: Test turns on the test tone generator to set speaker levels. To

route the test tone from one speaker to the next, press the Left or Right

Cursor buttons. Use the Up/Down cursor buttons to adjust levels. Press

Set when ﬁnished.

Other components

: Guide calls up the program guide on satellite receiv-

ers and cable boxes.

RC8 Cursor control buttons (menu navigation)

In general, the Up and Down cursor buttons select a particular function

or parameter from the on-screen menu while the Left and Right cursor

buttons adjust whatever function or parameter that’s been selected. Set

activates selections made while using the on-screen menu.

RC9 Direct/

dual function button (see page 40)

Model 1070

: Direct enables access to a radio station directly. Press once,

then enter the station’s frequency using the numeric keys.

Other components

begins the play function.

NIGHT

LAST

ENTER

VOL CH

SLEEP

TONE

CBL AUX VCR TV

SAT

TEST

GUIDE EXIT

INFO

PRESET DOWN DIRECT

VIDEO 1 VIDEO 2 VIDEO 3 VIDEO 4

CD AUX TAPE DVD

DOLBY MODES DTS MODES STEREO MODES BYPASS

PRESET UP

TUNE MODE AM / FM MEMORY

TRIM

7.1 OSD

SET

CD AMP TNR

PWR

21 3

54 6

7 9

MUTE SYNC

Model 1070 Remote Control

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 51 52

Comments to this Manuals

No comments

Outlaw Audio 1070 User Manual Page 10

Comments to this Manuals