Outlaw Audio 1070 User Manual download pdf (Page 41)

Model 1070 7.1 Channel Surround Sound Receiver

Owner’s Manual

Creating an AM or FM station-memory preset manually:

1. Tune the station you want to enter into memory following the

directions shown above.

2. Press the MEMORY button on the remote.

You will see “Memory” immediately above the broadcast frequency in

the front panel and on-screen displays.

If any station presets have already been entered, you’ll see a number

immediately after “Memory.” The ﬁrst digit of that number will ﬂash.

3. Within 5 seconds, enter a two-digit memory number (from 01 to

30) using the remote’s numeric keypad.

4. Wait a few seconds as the present number is entered into the

Model 1070’s memory.

The ﬁrst digit of the preset number will blink. This is your indication

that the memory is being loaded.

5. The word MEMORY changes to PRESET and the ﬁrst digit of the

number will stop ﬂashing.

This is your indication that the preset number has been memorized.

NOTE: If the memory number you have chosen was previously used

for another station, that memory will be overwritten with the new sta-

tion preset number.

AM station presets must be entered manually, they cannot be entered

using the automated process described below.

To create FM station-memory presets automatically:



Press and hold the remote’s MEMORY button for three seconds,

then release it.

The tuner will automatically scan the FM band for all active stations,

and create memory presets for the ﬁrst 30 stations tuned with a signal

that has acceptable strength for good reception.

To select a preset station:



From the remote, press the PRESET UP or PRESET DOWN buttons

to scan through the list of preset stations.

1. From the front panel, press the PRESET button.

Press the or buttons to scan through the list of preset stations.

Using Headphones

The Model 1070’s front headphone jack allows you to listen in private without

disturbing others nearby. You may enjoy headphone listening in either pure

stereo or thanks to the Model 1070’s Dolby Headphone processing, you can enjoy

a realistic surround-sound effect even when using headphones.

The Model 1070 has a 1/4-inch headphone jack, which accommodates the

1/4-inch plugs found on most quality headphones. If you want to use portable-

style headphones such as those included with portable CD or MP3 players, you

will need a stereo 1/8-inch to 1/4-inch adapter, which is readily available at

RadioShack and other electronics stores.

To use the headphones:

1. Plug a set of headphones in to the front panel using the headphone

jack.

The signal to the main speaker outputs will automatically mute when

the headphones are in use.

2. Use the HEADPHONE LEVEL CONTROL to the right of the

headphone jack to set the sound level for the headphones

The main system front panel or remote volume controls do not have any

inﬂuence on the headphone level setting.

CAUTION: We recommend that you turn the headphone level control

all the way down before using headphones for the ﬁrst time, and then

slowly increasing the level by turning the knob to the right. This avoids

the chance that you might damage your hearing by encountering a

headphone level that is too high. Always use caution and good sense

when setting the headphone level, as high levels may cause hearing

damage. Listening to headphones for prolonged periods at high vol-

ume levels can permanently damage your hearing

The headphones may be used in either the Stereo or Dolby Headphone mode.

To change the setting, go to the Surround Conﬁguration Menu, following the

instructions shown on page 33.

Model 1070 Operation

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 51 52

Comments to this Manuals

No comments

Outlaw Audio 1070 User Manual Page 41

Comments to this Manuals